Dernières nouvelles
Ajoutez une courte description pour votre blog.
Paused Long-Board Job: Prove the Reference Before Resuming
A pause, stop, home and disconnect do not preserve the same position evidence; verify non-output references before resuming a long...
Laser Frames but Stops Before Output? Save the First Console Error
If framing works but output stops, preserve the first console error, versions, profile and control-file result before changing the X1S...
Long Board Project: Map the Largest Uninterrupted Engraving Zone
Measure the largest continuous engraving zone, support, overhang, and travel before planning a long-board project.
Large Sign Has Photo and Cutline: Set the Process Order First
Assign photo, score, text, and profile operations in a verified order before running a mixed-layer large sign.
SVG Cuts the Same Edge Twice: Check for Duplicate Lines
Detect stacked SVG paths that make an X1S 2026 retrace one edge, then prove one cleaned traversal on scrap.
DXF Cutline Has Tiny Gaps: Find Open Paths Before a Large Cut
Find and repair tiny open-path gaps in a DXF before committing a large sheet to an X1S 2026 cut.
Large LightBurn Grid Shifts by Column: Check Start Position Mode
Diagnose a LightBurn grid that shifts by column with measured origin and start-position comparisons on X1S 2026.
Paper Will Not Lie Flat for Laser Cutting: Check the Frame and Weights
Plan approved low-profile perimeter restraint, verify full framing and head clearance, and supervise lightweight paper without loose beam-path weights.