Short answer: Use this page as a starter test grid for TYVOK X1S 20W. Confirm software units, material supplier, focus, air assist, and cleanup before using any setting for customer work.
Laser engraving settings chart
Full TYVOK material settings table
TYVOK machine buying guide
Shop TYVOK X1S 20W
TYVOK X1S 20W starter settings table
| Material | Starter speed | Power | Passes | Test note |
|---|---|---|---|---|
| 3 mm basswood plywood | slower mm/min grid | High | 1-2 | Two cleaner passes may beat one overheated pass. |
| 4-5 mm plywood | slower mm/min grid | High | 2+ | Glue layer and flatness matter. |
| Plywood batch layout | separate cut/engrave grids | Medium to high | 1+ | Save both engraving and cutting settings. |
How to use this test grid
Start with scrap from the same supplier and thickness. Change only one variable at a time, then save the tested speed, power, passes, photo, material source, and cleanup note. Keep cutting and engraving settings separate.
When to choose a different TYVOK path
If the job changes from compact marking to large-format cutting, or from diode work to clear acrylic, move to the machine family that fits the material path instead of forcing one preset across different laser types.
