Short answer: Use this page as a starter test grid for TYVOK X1S Pro 60W. Confirm software units, material supplier, focus, air assist, and cleanup before using any setting for customer work.
Laser engraving settings chart
Full TYVOK material settings table
TYVOK machine buying guide
Shop TYVOK X1S Pro 60W
TYVOK X1S Pro 60W starter settings table
| Material | Starter speed | Power | Passes | Test note |
|---|---|---|---|---|
| 3 mm plywood production cut | mm/min grid | High | 1 | Confirm edge quality after the first sheet. |
| 5 mm plywood production cut | slower mm/min grid | High | 1-2 | Watch glue layer, smoke, and sheet support. |
| Mixed engrave/cut job | two separate grids | Medium to high | 1+ | Do not reuse cut speed for engraving. |
How to use this test grid
Start with scrap from the same supplier and thickness. Change only one variable at a time, then save the tested speed, power, passes, photo, material source, and cleanup note. Keep cutting and engraving settings separate.
When to choose a different TYVOK path
If the job changes from compact marking to large-format cutting, or from diode work to clear acrylic, move to the machine family that fits the material path instead of forcing one preset across different laser types.
